CV Boot Replacement...
#3
It's easier and makes more sense to replace the whole driveshaft.
Tools needed:
32mm nut
pry bar
socket set
Take off the wheel, then remove the 32mm nut. Remove other nuts holding hub. Rotate the hub out of the way, use your pry bar and pry the drive shaft out. Replace with new one. Put hub, back together. Torque, back on the 32mm nut, to 35lbs I think.
Get alignment. Should take about 1 hour.
Tools needed:
32mm nut
pry bar
socket set
Take off the wheel, then remove the 32mm nut. Remove other nuts holding hub. Rotate the hub out of the way, use your pry bar and pry the drive shaft out. Replace with new one. Put hub, back together. Torque, back on the 32mm nut, to 35lbs I think.
Get alignment. Should take about 1 hour.
Thread
Thread Starter
Forum
Replies
Last Post