Integra Technical Questions and Tips Tech discussion for all things Acura Integra

Ignition issue?

Thread Tools
 
Search this Thread
 
Old 06-09-2006, 11:06 PM
  #1  
n00b
Thread Starter
 
bigfoot6913's Avatar
 
Join Date: May 2006
Location: Barrie
Posts: 16
Default Ignition issue?

After hell week with my car (check out the General discussion forum for my little story), I have one problem left.

My car will not start when left in the sun!

Now, I remember from back in the day with my 1990 skylark that my mechanic said sometimes ignition modules act up in the heat when the get old and worn out.

Does this sound right to you guys?

And at the risk of seeming a little daft, Is the ignition module the "distributor"?


Any help is appreciated
bigfoot6913 is offline  
Old 06-10-2006, 12:19 AM
  #2  
rey
Junior Member
 
rey's Avatar
 
Join Date: Jul 2003
Location: toronto
Posts: 302
Default

Thats not it,


It is the Main Fuel Relay that is located under the dash on the driver side, directly above the interior fuse box (clutch pedal). The connections wear out over time not allowing the car to start. If it happens again, reach under and wiggle the relay or hit the dash (by the turning signal) and it should start. (Also, wait for the fuel pump to prime before you start the car and give it some gas). HTH
rey is offline  
Old 06-17-2006, 12:17 AM
  #3  
n00b
Thread Starter
 
bigfoot6913's Avatar
 
Join Date: May 2006
Location: Barrie
Posts: 16
Default Pic?

Can someone post a pic of the relay. Im sure that I can figure it out when I buy a new one, but I would just like to know for sure if its the right part. Experience has taught me that the part they give you has a one out of 8 chance that its is not the right part regardless of the box or computer says. The sad part is in my experience one out of those right 7 is defective from the factory.

Thanks for the help guys
bigfoot6913 is offline  
Old 06-27-2006, 02:16 AM
  #4  
Member
 
Frost YO[SMCR]'s Avatar
 
Join Date: Jul 2003
Location: Rexdale
Posts: 721
Default

your car main relay.. its under the driver side dash to the left.

its a little box with a serial number on it. the sodder on the back of it will running causing breaks in the connections....

my 2nd gen did it all the time in the summer. get a knew one or opens ur up n lay some new sodder lines in but becareful and dont burn the boards. a new relay is like 20 bucks for like a used one.
Frost YO[SMCR] is offline  
Old 06-27-2006, 05:36 PM
  #5  
Time to become a Premier Member!
 
WildoutWhiteGSR's Avatar
 
Join Date: Aug 2003
Location: Whitby
Posts: 4,816
Default

Need a new main fuel relay or a new ignitor which is located in the distributor
WildoutWhiteGSR is offline  
Old 07-04-2006, 10:16 AM
  #6  
n00b
Thread Starter
 
bigfoot6913's Avatar
 
Join Date: May 2006
Location: Barrie
Posts: 16
Default Good goin guys

Thanks for the tips guys. I pulled the damn thing out and carried it with me in the nice A/C every day for about a week before it finally gave up on me. I got the new one from Acura and the car has no problems starting at all. Though I seem to have minor idle problem. What RPM should my car idle at? Is it possible that a sensor got dirty from the incorrectly operating fuel relay? Its fine at high idle when I turn it on. Its fine after high idle kicks down. After it gets warmed up though it starts to idle around 500 and drops as low as 300. Any info is a big help guys.
bigfoot6913 is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
midnight_breeze33
Integra Technical Questions and Tips
16
02-19-2007 10:38 PM
Varrus
Integra Technical Questions and Tips
3
02-04-2006 04:00 AM
93tegDude
Integra Technical Questions and Tips
41
08-19-2005 01:43 PM
DRT acura
Integra Technical Questions and Tips
0
08-19-2005 07:55 AM



Quick Reply: Ignition issue?



All times are GMT -5. The time now is 01:14 AM.