B series header?
#4
yes? no? maybe so?
aha yea bro it should fit but where it meets up with the cat it might be to short or 2 long so you may need to either lengthen the b pipe or shorten it. Not sure how close it would be
aha yea bro it should fit but where it meets up with the cat it might be to short or 2 long so you may need to either lengthen the b pipe or shorten it. Not sure how close it would be
#8
b/c the whole 9mm taller deck height of the b18c will even make a difference (NOT).
I've used a header off my b16 on a LS integra without any problems (other than the collector flange being on a different angle than the LS's catylitic converter flange).
And i know the ITR has a 212.39mm deck height VS the b18a/b deck height of 211.84mm VS the b16/b17's deck height of 203.25mm.
Unless your b16 header hugs the oil pan (clearance of less than 10mm or 1cm) than it will fit the ITR/GSR/LS block....trust me.
I've used a header off my b16 on a LS integra without any problems (other than the collector flange being on a different angle than the LS's catylitic converter flange).
And i know the ITR has a 212.39mm deck height VS the b18a/b deck height of 211.84mm VS the b16/b17's deck height of 203.25mm.
Unless your b16 header hugs the oil pan (clearance of less than 10mm or 1cm) than it will fit the ITR/GSR/LS block....trust me.
Thread
Thread Starter
Forum
Replies
Last Post
cube
Integra Parts For Sale
1
07-22-2013 11:16 AM
Rrebel YO
Integra Parts Wanted
0
08-25-2007 01:08 AM
DXmike
Integra Parts For Sale
7
07-15-2007 01:17 PM
nightstick
Integra Parts For Sale
7
07-07-2007 11:56 AM