What type of suspension setup are You using??
#8
block my plate sicko, wait till i come home im gonna beat you
and since this is toronto integras im sure the OP was asking about teg suspension, HR Race on a teg is gonna be stiffer than on a TL
so instead of post whoring TI, GO DO SOME WORK ON THE TEG
and to make this post relative:
we are gonna be putting Skunk2 PRO-C coilovers on the DA
and since this is toronto integras im sure the OP was asking about teg suspension, HR Race on a teg is gonna be stiffer than on a TL
so instead of post whoring TI, GO DO SOME WORK ON THE TEG
and to make this post relative:
we are gonna be putting Skunk2 PRO-C coilovers on the DA
#16
IMO... i bleev Skunk2 is really good especially for Honda and Acura parts... hopefully soon I will be ordering my suspension... but if you want.. you can msg Red_Tegger... his DA is amazing... it looks reall nice.. just nto sure of his setup
#21
Tein HA - 8k front, 6k rear (12k 8k for track)
Tein EDFC
stock ITR 24mm front, JDM '98-spec ITR 23mm rear sway
Do-Luck room bar
J's Racing c-pillar bar
front & rear STB
trunk bar
rear lower tie bar
Tein EDFC
stock ITR 24mm front, JDM '98-spec ITR 23mm rear sway
Do-Luck room bar
J's Racing c-pillar bar
front & rear STB
trunk bar
rear lower tie bar
Last edited by Project X; 09-19-2007 at 11:16 PM.
#24
#25
got track/street
tein type flex coilovers
tein front / rear strut bar
tein edfc
J's racing c pillar bar
omni lower control arms
skunk front and rear camber kits
asr subframe kit
asr sway bar links
type r rear sway bar
complete poly bushing kit
rides rellie stiff when needed, for daily driving its a bit harsh on bumpy roads thoe, its a given
tein type flex coilovers
tein front / rear strut bar
tein edfc
J's racing c pillar bar
omni lower control arms
skunk front and rear camber kits
asr subframe kit
asr sway bar links
type r rear sway bar
complete poly bushing kit
rides rellie stiff when needed, for daily driving its a bit harsh on bumpy roads thoe, its a given
Last edited by Mike935; 09-20-2007 at 10:16 PM.
Thread
Thread Starter
Forum
Replies
Last Post