Torque specs

Reply Subscribe

Thread Tools

Search this Thread

Jan 21, 2010 | 04:28 PM

Spydersniper9

Thread Starter

Junior Member

Joined: Sep 2009

Posts: 118

From: Belwood

Torque specs

I'm putting in a new flywheel and clutch this weekend what are the torque specs for the flywheel pressure plate and tranny case for a 96 integra rs

Jan 21, 2010 | 04:42 PM

JDM_overdose

There's plenty to do outside my room but I choose not to!

iTrader: (9)

Joined: Jul 2005

Posts: 5,141

From: 43°04′48″N-79°04′16″

flywheel

Torque in steps: 19ft-lbs (228in-lbs), 38ft-lbs (456in-lbs), 57ft-lbs (684in-lbs), Then to 76ft-lbs (912in-lbs) (all B series)

CLUTCH COVER LOWER BOLTS (8mm)
17ft-lbs (204in-lbs) (all B series)

CLUTCH COVER UPPER BOLTS (6mm)
9ft-lbs (108in-lbs) (all B series)

Jan 21, 2010 | 05:29 PM

Spike

There's plenty to do outside my room but I choose not to!

iTrader: (5)

Joined: Apr 2009

Posts: 5,142

From: Burlington

Just use a ratchet and socket and make sure they are tight, that's all you need to do.

Jan 21, 2010 | 05:49 PM

Spydersniper9

Thread Starter

Junior Member

Joined: Sep 2009

Posts: 118

From: Belwood

Nah I'd rather Use a torque wrench and make sure they're tight

Jan 21, 2010 | 05:59 PM

JDM_overdose

There's plenty to do outside my room but I choose not to!

iTrader: (9)

Joined: Jul 2005

Posts: 5,141

From: 43°04′48″N-79°04′16″

+1

If you know how tight they were when they came off, you can put them back on without torquing it.

Quote:

Originally Posted by Spike

Just use a ratchet and socket and make sure they are tight, that's all you need to do.

Jan 21, 2010 | 06:15 PM

D.T.P

Moderator

iTrader: (3)

Joined: Apr 2009

Posts: 2,551

From: maple

Lol never use a torque wrench. Did my pressure plate with a long wrench, then put another wrench at the end to extend and gave a good push with my weight. Worked like a charm. Lol