93tegralsv

hey guys , needed some help and feedback on doing this build . my buddy that I was dealing with kinda flopped on me, cuz I didn't wanna go with his builder cuz he's overpriced , n now its like I hit a wall n dunno Wut else that I need 2 do to make it a successful build .
will the valves hit the pistons ? here's my list of stuff that I have so far : *b16a1 Head
*Skunk2 pro2+ Cams
*Skunk2 Valves springs
*Skunk2 T.I. Retainers
*Skunk2 Cam gears
*Hytech headers
*Hasport Engine mounts
*B18b Block -
*660cc Fuel injectors
* p06 (chipped)Ecu
* B&M adj fuel pressure regulator
*hydro fuel pressure gauge
*GSr Timing belt
*GSr tensioner
*GSr Water pump
*aem fuel rail
*aem wideband gauge
*B16 distributor
*arp head bolts
*81.5mm ls high comp. ( hemi) forged pistons and rods .
will the valves hit the pistons ?
so if you guys Can help me out it would be greatly appreciated .

MPR

Not sure if there will be piston to valve cantact. It may depend on your cam timing.

You'll have to clay the motor to find out what your clearance will be. You may want to let a reputable shop handle this sort of thing. Building a typical motor is completely do-able on your own. But building a high compression NA motor is another story. You really need to know what you're doing...