installing cold air intake on 92 integra

Reply Subscribe

Thread Tools

Search this Thread

08-19-2006, 11:00 AM

Lazee

n00b

Thread Starter

Join Date: Aug 2006

Location: Toronto

Posts: 2

installing cold air intake on 92 integra

Does anyone have installation instructions for cold air intake? I bought a AEM knock off intake from ebay and there are no instructions with it. I want to try to do it myself before I pay someone else to do it.

Lazee

08-19-2006, 11:12 AM

DRT acura

Senior Member

Join Date: Dec 2004

Location: London

Posts: 1,305

Removing Intake Resonator.
You have to take off your front bumper (two screws in on each fender lip, two bolts behind each bumper signal, and a couple underneath). Now all you have to do is remove the three bolts that hold the resonator in. Two out of the three bolts are kind of hard to see and you are going to need a long socket extension to reach them. Once it is unbolted, pull it out. DONE! Real simple. Might take you 20 minutes. Best of luck to you.

If you don't want to take off your bumper, you can just take off the cover under the resonator (plastic mudguard that covers under the passenger side fender and underneath part of the front bumper). After you take that panel off, just take off the resonator by unbolting them.

DSpeedRacr

The bolt sizes on the bumper and resonator (at least on my '90 LS) are 10mm and 12mm. The larger bolts behind the bumper signal lights are 12mm and the bolts under the car are 10mm, as are the 3 bolts holding on the resonator. All screws are Philips.

Killa Gram