Help, tranny drain bolt
#7
Originally Posted by Smartass pHO
I doubt that.
3/8" or 1/2" for sure.
3/8" or 1/2" for sure.
http://www.c-speedracing.com/howto/t...transfluid.php
Last edited by Stealth1; 08-24-2006 at 02:45 PM.
#16
u guys are talkin b.s [ the right way to do it] u need a 17mm wrench and remove the 17mm nut on the tranny case, that is the fill hole.the drain hole is below to ur right it does not drain until u over fill so u r going to vac if u want to drain. the 3/8 slot i would advice u to try it i did. AND FILL UNTIL IT STARTS COMIN OUT THEN CLOSE
Thread
Thread Starter
Forum
Replies
Last Post
Valo666
Integra Technical Questions and Tips
4
07-13-2007 02:36 PM