Clutch Squeak Solution
#1
Clutch Squeak Solution
When I pressed my cluch, I heard a weird squeak. First i thought it was coming from my pedal greased that, the noise was still there. It began to be so loud i could hear it while shifting. I figured it was coming from my engine bay, did some research and found out how to remove it. Thanks to Fuzzy for his car is used in this article.
MODS, may want to sticky this for current and future memebers.
Hope this helps, supposedly this is a common problem in Honda's
Product required:
Brake caliper/slider pin grease
(can be easily found at crappy tire)
Take the Boot off from the tranny and slave cylinder, push it to the left as much as possible.
Now you want to take off this boot and push that as far as you can to the left to expose the rod underneath.
Now take your caliper pin grease
Now apply it to the rod of the slave cylinder
Now replace your all your boots and pump your clutch a couple times to get it through, and apply more if needed. Hopefully your squeak will be gone.
MODS, may want to sticky this for current and future memebers.
Hope this helps, supposedly this is a common problem in Honda's
Product required:
Brake caliper/slider pin grease
(can be easily found at crappy tire)
Take the Boot off from the tranny and slave cylinder, push it to the left as much as possible.
Now you want to take off this boot and push that as far as you can to the left to expose the rod underneath.
Now take your caliper pin grease
Now apply it to the rod of the slave cylinder
Now replace your all your boots and pump your clutch a couple times to get it through, and apply more if needed. Hopefully your squeak will be gone.
Last edited by Platinum Playa; 07-11-2005 at 07:43 PM.
Thread
Thread Starter
Forum
Replies
Last Post