Hey guys, I finally got around to working on my 94 ls. When I purchase dit the seller said it needed a clutch. Got under the hood last week and noticed the fluid was empty. I topped it off and bled the system, the pedal sits perfect nopw and the car will now start buut when placed into gear it wont move. Any ideas? does it need a clutch or is there anything else to adjust? Thanks guys.

 

do you hear any noises?

 

no noises at all. Starts and put it into gear the car just reves up thats it. But no od noises.

 

Make sure that the clutch slave is moving the clutch fork, and if it is, you most likely need a clutch.

 

how would i check this? New to these hydrolic cluthes

 

you would need some one to press on the clutch pedal from inside the car, and you just look at the slave to see if it is pushing on the clutch fork.

 

thx ill go check it out. Hope not then gotta pull it apart tomorrow