FS: B16 cylinder head
#1
FS: B16 cylinder head
ok guys
i have this head sitting in my garage and i have no time to rebuild it and i don't have any use for it anymore.
the good:
already modified for B20/VTEC
shaved apporx .045"
fully ported
crower dual valve springs
crower ti-retainers
chamber bores opened up to 84mm
comes with stock B16 cams
the bad:
requires new guides, seals, valve job.
head is completely disassembled.
needs a good cleaning.
thats about it. the head now has 84mm bores. i do not think it will seal properly on a 81mm block so this will pretty much only work on a B20 or a sleeved 84mm bottom end.
asking 250obo
contact: vtec2 @ sympatico.ca or pm me.
i have this head sitting in my garage and i have no time to rebuild it and i don't have any use for it anymore.
the good:
already modified for B20/VTEC
shaved apporx .045"
fully ported
crower dual valve springs
crower ti-retainers
chamber bores opened up to 84mm
comes with stock B16 cams
the bad:
requires new guides, seals, valve job.
head is completely disassembled.
needs a good cleaning.
thats about it. the head now has 84mm bores. i do not think it will seal properly on a 81mm block so this will pretty much only work on a B20 or a sleeved 84mm bottom end.
asking 250obo
contact: vtec2 @ sympatico.ca or pm me.
#3
Thread
Thread Starter
Forum
Replies
Last Post
zman
Integra Parts For Sale
12
08-25-2008 10:01 AM