Ignighted switch in DA
#1
There's plenty to do outside my room but I choose not to!
Thread Starter
iTrader: (9)
Join Date: Jul 2005
Location: 43°04′48″N-79°04′16″
Posts: 5,142
Ignighted switch in DA
I had this in my DC, I wanted to put it in my DA.
What I have it for is fog lights, I decided to put the fogs on my DA now. Fogs are not setup, just the switch with all the wiring.
Step 1- Pry out the pannel that has no use(beside your dimmer) Use a flathead.
Step 2. If you have a vise, put the pannel inbetween the vise. If you dont have a vise put it inbetween your feet and hold it still on the floor with your feet.
Step 3. Get a drill and a pointy drill bit(I used a flathead piece so it would make the hole bigger, I dont have the proper bit).
4. Put the switch through the hole from the bottom **MAKE SURE YOU DONT BREAK THE CLIPS ON THE PANNEL**.
And your done.
What I have it for is fog lights, I decided to put the fogs on my DA now. Fogs are not setup, just the switch with all the wiring.
Step 1- Pry out the pannel that has no use(beside your dimmer) Use a flathead.
Step 2. If you have a vise, put the pannel inbetween the vise. If you dont have a vise put it inbetween your feet and hold it still on the floor with your feet.
Step 3. Get a drill and a pointy drill bit(I used a flathead piece so it would make the hole bigger, I dont have the proper bit).
4. Put the switch through the hole from the bottom **MAKE SURE YOU DONT BREAK THE CLIPS ON THE PANNEL**.
And your done.