Pic's are here
Thread Starter
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Joined: Apr 2009
Posts: 5,142
From: Burlington
Well here are a few pictures i took last night. Installed new rear lower control arms and a rear lower tie bar.

Before:

After:

Before:

After:
Thread Starter
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Joined: Apr 2009
Posts: 5,142
From: Burlington
Thanks, i just installed a rear C-piller bar just now in silver aswell. Thats my civic and I put the front springs in the rear and the rears in the front, just for the hell of it, but I was not expecting it to go that low,lol. Now once it get the front springs out from the integra, i will throw them into hte front of the civic to get some hight back,lol. The Teg needs a little bit of work, but it's not to bad over all.
Thread Starter
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Joined: Apr 2009
Posts: 5,142
From: Burlington
It need a new front bumper and driver fender, and a little rust fixed up, and then a buff job or i'll just get the hole think painted now insted of winter time. I still need to take the passenger seat from the civic and install it, as i did the driver seat today aswell, and I need to switch the cat back for both cars around (maybe) i mite just get a skunk2 catback when i get back from school,lol.
Thread Starter
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Joined: Apr 2009
Posts: 5,142
From: Burlington
^^^ it's as bad as it looks. the body is in pretty good condition, and there are no hold under the car, and the brake lines have like no rust on them, and tyou dont see that very often on these.
Thread Starter
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Joined: Apr 2009
Posts: 5,142
From: Burlington
Thread Starter
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Joined: Apr 2009
Posts: 5,142
From: Burlington
Do install what, the lower control arm, not long if none of the bolts are seized, but if they are, they will take longer.
Thread Starter
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Joined: Apr 2009
Posts: 5,142
From: Burlington
hey man i have a question.. i was supposed to install springs the other day but my bushings are done so i think i need new arms too.. do you know how much it would cost to get arms?? and how much would it cost u to install.. pm me.. thanks




