delete....

 

front or rear?

 

front...i think i need everything..i already took off the caliper, brake pads, and rotor but it seems i still need to remove the hub/bearing..aarrgghhh...it always happen to me on the holidays when everything is closed....bah!!

 

your not going to be able to remove the front hub in your garage unless you have a press. you have to press out the hub from inside the wheel bearing then it has to be pressed back in.

also a word of advise you better buy a new wheel bearing at the same time. 98% of the time the wheel bearing get totaly fucked when trying to press out the hub.

 

If you have a dremil and a lot of spare time, you can can grind a piece of the knuckle off near where it bolts onto the heat sheild. You'll have to remove the heat sheild. I run without one as do most of the people in my club, but some people like to keep there's in place. You just need to grind enough of it away to be able to knock out the stud and push a new stud in. Then spin the hub and do the next one. Tigthten your wheel nut to pull the stud all the way through.