underbody and passenger side splash guards...
#1
underbody and passenger side splash guards...
Hello fellow Integra drivers. I like to replace my front underbody splash guard. The **** hangs too low, constantly scraps and looks like it drools. It needs to be replaced.
My passenger side splash guard is fucked up as well.
Other than junkyards and Honda, any idea where I can get quoted for these plastic parts?
Much thanks,
Gracias.
My passenger side splash guard is fucked up as well.
Other than junkyards and Honda, any idea where I can get quoted for these plastic parts?
Much thanks,
Gracias.
#8
Hey guys, I still need a right side (passenger side) inner fender liner, i currently have one that's for the 94-97 integers, the holes are different, can't put on the nose mask.
WTB, will pick up
WTB, will pick up
#10
You need something there to keep debris and stuff from coming up into the engine bay.
Half of mine is missing/broken and the engine bay gets dirty FAST. But I'm planning on making my own new splash gaurd/under-tray some time before winter (hopfully).
I'd try to find a replacement and definitely not just remove it and drive without one.
Half of mine is missing/broken and the engine bay gets dirty FAST. But I'm planning on making my own new splash gaurd/under-tray some time before winter (hopfully).
I'd try to find a replacement and definitely not just remove it and drive without one.
#11
You need something there to keep debris and stuff from coming up into the engine bay.
Half of mine is missing/broken and the engine bay gets dirty FAST. But I'm planning on making my own new splash gaurd/under-tray some time before winter (hopfully).
I'd try to find a replacement and definitely not just remove it and drive without one.
Half of mine is missing/broken and the engine bay gets dirty FAST. But I'm planning on making my own new splash gaurd/under-tray some time before winter (hopfully).
I'd try to find a replacement and definitely not just remove it and drive without one.
I made one for my GSR for RallyX and now I made a better one for my 99 Civic. It again will be improved upon.
Best material so far is 3/16" aluminum plate. Mounting takes some creativity and a rear brace.
They do an excellent job of keeping dirt away, moving air along the bottom and finally offering the utmost protection. Plus the are much cooler than flimsy plastic
Thread
Thread Starter
Forum
Replies
Last Post
acurreo
Integra Parts Wanted
0
05-21-2008 11:52 AM