frogboy001

whats the easyest way to run the speaker wire into the doors? iv been thinking of just drilling a hole...

Buff4Prez Yo

iTrader: (2)

run it through where the factory wiring is going through

frogboy001

ya but its a bitch to get it through there

WildoutWhiteGSR

http://www.team-integra.net/sections...?ArticleID=257

GSR_gino

dude it depends if you want a clean install or a hack job. by what youre saying it looks like youre gonna do a hackjob. u cant just drill it when u open the door the wire will stretch and then when u close it itll be folded inbetween the door and frame and over time the wire will get fucked up. take the extra time now, get a metal coat hanger and fish it through. its not hard.

frogboy001

lol ok im gonna try it this weekend

acurreo

this is good ----.

frogboy001

i just looked at the plug quick and i dunt kno how to unplug it on my da? its different then the g3...

bbTeg

go through the factory location, honda's rust bad enough on thier own... they don't need your help.

Milad

since it's hard to run it through the stock place. Beside that stock hole just feed a coat hanger in and tape the wire on the top of the coat hanger and feed the coat hanger in the hole and grab it with your two fingers from other side, if wires are still showing? grab a black tape and tape over the wires, easiest way..