so just finished installing the clutch. anyways when i press the pedal all the way i hear this little chatter noise like something scraping. but it changes gear fine everything is fine.

Im thinking its the release bearing even though it was brand new. Well i hope its not that.

im just going to break it in and see if i still hear the noise after 400-500 km.

 

^^
that sounds like a good idea. mind you, the a defective release bearing makes a whizzing noise. however, i wouldnt rule out the possibility. perhaps a misalignment of the PP assembly? most importantly, did you get the flywheel machined as well? it will be interesting to find out what the problem really is

 

yes i got the flywheel machined. I hope its just a matter of break in.

 

i ran into that problem before.. it was the pressure plate. either not aligned or not torque properly

 

^^ negative

the release bearing is actuated when the clutch is "released"/depressed/pedal is down. the fact is that the throw out bearing is the point where the stationary portion of the clutch system meets rapid high speed roation on the system.

i second the above post of an improperly torqued PP

 

i think i just got a hard on. hahaha...jk

 

adjusted my clutch cable and its now perfection. clutch has been broken into and love the feel especially with typeR flywheel.