Mis Fire
Time to become a Premier Member!
Joined: Mar 2003
Posts: 3,446
From: .....................................................
Did you pull the actual code from the ECM?
After installing the aforementioned, did you reset the ECM?
Start there then report back.
Use the Integra service Manual or Helms
After installing the aforementioned, did you reset the ECM?
Start there then report back.
Use the Integra service Manual or Helms
Junior Member
Joined: Oct 2004
Posts: 386
From: Downtown TO
Do you have a check engine light? There's a way to pull the code from the check engine light. If you don't have one chances are it's electrical.
My car misfired with no check engine light when my aftermarket plug wires arched and when a quad platinum plug failed (those things are *****). It did come on I believe when I blew a dizzy. What's the mileage on your plugs, wires and dizzy?
My car misfired with no check engine light when my aftermarket plug wires arched and when a quad platinum plug failed (those things are *****). It did come on I believe when I blew a dizzy. What's the mileage on your plugs, wires and dizzy?
Junior Member
Joined: Oct 2004
Posts: 386
From: Downtown TO
Ew. That could be bad. I'd start with a compression test to rule out the bottom end...bent rods, rings etc. Then pull the head and look for bent valves and a blown head gasket. Is there coolant in your oil or oil in your coolant? Are you losing coolant? Is the smoke in the tailpipe white or blue?
Junior Member
Joined: Oct 2004
Posts: 386
From: Downtown TO
White is coolant, blue is oil and black is the fuel is rich. Sounds like a sick motor if you're losing oil too. 
The no oil in the coolant worries me a little. Not a lot, might still be a head gasket. Take it in and get it checked out. If it is a motor, it's cheaper to pick up a low mileage one from an importer than trying to fix yours. Could also be an opportunity to pop in a bigger motor. 
B20s can make some good power now days, and the torque is stronger than an ITR. Think they run around 1100 for a long block.
The no oil in the coolant worries me a little. Not a lot, might still be a head gasket. Take it in and get it checked out. If it is a motor, it's cheaper to pick up a low mileage one from an importer than trying to fix yours. Could also be an opportunity to pop in a bigger motor. B20s can make some good power now days, and the torque is stronger than an ITR. Think they run around 1100 for a long block.
Guest
Posts: n/a
If I swap in anything it'll probably be a GSR, and my oil stopped burning, misfire is still there, but i think its because the cyl with the plugs getting flooded, n the burning oil came from me flooding the oil into the motor. timings off too. and the valves need to be adjusted. all getting done this week, then the governor is coming off..and the ECU getting chipped, installin an engine management system * tuning comp* and it should be good
Junior Member
Joined: Oct 2004
Posts: 386
From: Downtown TO
That's a relief. Get your mechanic to take a look. Maybe the ignitor is faulty. Obvious place to start is to swap in fresh spark plugs, ignition wires, and distributor cap/rotor but with only 8K on your setup it's not likely - but you might have got bad parts, it does happen. If that doesn't help, then look at swapping in a good ignitor and/or coil. Beyond that, it could be an electrical gremlin, something as simple as a loose connector to the ECU, loose ignition wire, had a friend who got a missfire and tracked it down to a cracked ground wire near the thermostat. At least the motor is good and sounds like you're putting in some pretty trick parts.
