microwave sensor wiring
Thread Starter
n00b
Joined: Aug 2008
Posts: 34
From: t.o
microwave sensor wiring
I own a first generation Compustar 2WFMAS. I recently purchased a DEI 508D dual zone microwave sensor (vehicle exterior + interior). The unit has four wires coming from it: red (pos +), black (ground), green (-) first stage "warn away", and blue (-) second stage "full alarm" trigger. I was wondering which inputs I would need to connect to my compustar module to make this work on both first and second stage?
someone told me this
First you will need to get power and ground from the main harness, then your first stage you can wire to a relay that will send a positive trigger to your siren. Fro the final stage to set the alarm off you will want to hook the wire to an input trigger on your system, hood, trunk, or door. That should give both 1st and 2nd stage on your proximity sensor.
im trying to draw a plan to wire the relay but i cant figure it out. can anyone help?
someone told me this
First you will need to get power and ground from the main harness, then your first stage you can wire to a relay that will send a positive trigger to your siren. Fro the final stage to set the alarm off you will want to hook the wire to an input trigger on your system, hood, trunk, or door. That should give both 1st and 2nd stage on your proximity sensor.
im trying to draw a plan to wire the relay but i cant figure it out. can anyone help?
Thread
Thread Starter
Forum
Replies
Last Post
