Horn fuse
#5
LOL, check the wires to the horn they get very corroded, pull the horn off and put 12v directly to the horn to test the horn itself, that will tell you if you need a new horn or if the problem is within the wire or ground
#6
For sure the wires to the horn, located in the bumper by the bumper signals, are corroded as stated above. There are two horns working together (one on either side) so you can disconnect the one that is causing you trouble until you get it fixed.
Thread
Thread Starter
Forum
Replies
Last Post
Big Hairy Gino
Integra Technical Questions and Tips
9
04-29-2005 07:00 PM