im doing a gsr swap in my rs and i was wondering if anyone knows where to add the 2 vtec wires and knock sensor wire in the ecu plug, i didnt get the section of harness between the strut tower and the ecu so im just gunna add pins in the connector

 

The Vtec wire goes to A8 and the Knock sensor goes to B19

Here is a pic of the pin outs its small but it will give you the right idea.

http://rgenracing.webs.com/2.JPG

I hope this is right, I did this myself about 2 years ago but don't know if that's 100% correct.

Got it from this site with a quick write up, didn't read it, but might be useful.

Good luck

 

I personally just bought a vtec subharness for mine when I did my swap. Worth looking into if you can't figure it out.

 

i found the pin locations, its for a 96 rs forgot to mention that, a8 c15 and d6 i just need to find a 97 gsr OBD2 ecu and knock sensor connector, where would be the best place to get these

 

alright got another question, i went to put the power steering bracket on from the b18b1 cause i didnt get a bracket with the gsr engine and realized its different so i have to get that, but will the power steering pump from a b18b1 fit the b18c1 bracket?

 

nice. good info on these message boards