gsr swap
 

im doing a gsr swap in my rs and i was wondering if anyone knows where to add the 2 vtec wires and knock sensor wire in the ecu plug, i didnt get the section of harness between the strut tower and the ecu so im just gunna add pins in the connector

Re: gsr swap
 

The Vtec wire goes to A8 and the Knock sensor goes to B19

Here is a pic of the pin outs its small but it will give you the right idea.

http://rgenracing.webs.com/2.JPG

I hope this is right, I did this myself about 2 years ago but don't know if that's 100% correct.

Got it from this site with a quick write up, didn't read it, but might be useful.

Good luck

Re: gsr swap
 

I personally just bought a vtec subharness for mine when I did my swap. Worth looking into if you can't figure it out.

Re: gsr swap
 

i found the pin locations, its for a 96 rs forgot to mention that, a8 c15 and d6 i just need to find a 97 gsr OBD2 ecu and knock sensor connector, where would be the best place to get these

Re: gsr swap
 

alright got another question, i went to put the power steering bracket on from the b18b1 cause i didnt get a bracket with the gsr engine and realized its different so i have to get that, but will the power steering pump from a b18b1 fit the b18c1 bracket?

Re: gsr swap
 

nice. good info on these message boards