|
grinding in third
question for all the teg owners .so im driving doesn't matter what speed gearing up or gearing down but as soon as i put it in third it grinds not hard but soft and grinds for like 2 seconds what could i do
should i just put syncromesh or..................... |
synchro's are gone man, synchromesh isn't gonna work.
|
Mine does the same thing. If I shift over a 2500rpm it grinds. If I ----- drive it its ok.. But it keeps getting worse and worse. 3rd gear is famous for this. Buddy of mine has the same thing in a jbody.
Replace your tranny. Thats what I'm going to end up doing |
at this point, Synchromesh would not be that useful for that transmission.
You can either get another transmission as suggested, or you can have the transmission rebuilt! There are several places to take your transmission to to have it rebuilt, including affiliates on TI. Shouldnt cost too much, when I did my type R LSD transmission I had my 1st, 2nd and 3 gear synchro's changed in favour of the carbon coated synchro set from www.gearspeedinc.com And I was able to have them installed in my transmission w/ new bearings for a service charge of $200 from a very well known Honda performance shop. Hope this helps Travis |
Originally Posted by djtrini
(Post 195168)
at this point, Synchromesh would not be that useful for that transmission.
You can either get another transmission as suggested, or you can have the transmission rebuilt! There are several places to take your transmission to to have it rebuilt, including affiliates on TI. Shouldnt cost too much, when I did my type R LSD transmission I had my 1st, 2nd and 3 gear synchro's changed in favour of the carbon coated synchro set from www.gearspeedinc.com And I was able to have them installed in my transmission w/ new bearings for a service charge of $200 from a very well known Honda performance shop. Hope this helps Travis |
you might also want to check the tranny oil level if you haven't already done so. Sometimes the B-series trannies will grind and slip if your tranny oil level is too low
|
i put in syncrommesh still grinds looks like ill be putting in a new tranny
|
Originally Posted by smith_customs
(Post 195292)
i put in syncrommesh still grinds looks like ill be putting in a new tranny
|
plz help me out find the post or tell me what to do thx
|
looked and i cant find it
|
turn leave the ca running push the shifter to the grinding gear (3rd for u) with out stepping the clutch and rev to 3000 rpm now keep pushing the shifter like y r trying to go in gear,but not thta hard . keep pushung n reving around 6-7000rpm u should push right into gear.do this few time should fix problem. it did for me n alot other people. let me know the result:yeah:
|
wow u need to type a little slower . and if i push it into gear my car will stall cuz my foot is not on the clucth dont worry fond the link and posted it in the general discussion and the diy forum
|
Originally Posted by smith_customs
(Post 195422)
wow u need to type a little slower . and if i push it into gear my car will stall cuz my foot is not on the clucth dont worry fond the link and posted it in the general discussion and the diy forum
|
| All times are GMT -5. The time now is 11:54 PM. |
© 2026 MH Sub I, LLC dba Internet Brands