small and annoying problem. My gas gauge isn't working. Its way below empty, and theres plenty of gas in it. Anybody had a problem like this? Could it be a fuse, or wiring? everything else on the cluster works fine. Any suggestions?

 

did u replace the cluster?? or is that the one that came wit your car

 

its not the original cluster. it is a gsr cluster, but it was in the car when i bought it and working fine....

 

i changed my gas tank and i have the same problem too

i top up my gas every 350-400 km now though

 

^ If you re-used the sending unit..... prob damaged it during the swap...

and as for the initial question of the gauge not working... hard to say could be a connection... could be the cluster... could be the sending unit. What I would do if I were you is pull the cluster out... it's only 5 screws and will take about 5-10 mins.. start by checking the connection at the back..

James

 

^^^ +1 what james said. if that fails and you still have the original cluster swap out the gas gauge and voila, should work again.

 

thanks for the feedback guys....just yesterday i got behind the cluster, and checked everything there, but all seems fine.... however i could be wrong, not very savvy when it comes to electrical stuff....anyone know how much is might cost to replace the sending unit???

 

try changing the green backing on the cluster thats wut i did to get my gas needle to work when i swapped the originial for a tyrp r one./...