Clutch Squeeks
#1
Clutch Squeeks
I am having this wierd problem, I changed my entire clutch this summer with OEM honda parts. Recently I've noticed that my clutch is making a squeeking sounds when ever there is no pressure on the clutch, but once I apply even the slightest pressure to the clutch padle it goes away... any ideas?
John
thanks for helping
John
thanks for helping
#4
when you press the cluth, where exactly do you hear the noise from? you may need two people to do this because it echoes like crazy in the engine bay and its hard ti diagnose.
could also be your clutch throw out bearing if your hearing the noise within the tranny.
could also be your clutch throw out bearing if your hearing the noise within the tranny.
#5
well after some research on T.I, its either the throw out bearing which I am hoping that it isn't, or the clutch fork which needs greasing.. But the strange part is that people are getting when they engang the clutch, but I only get it when I dont engang the clutch, even with the slightest pressure on the clutch peddle it goes away. Wierd..
#6
The slave cylinder is sqeaking.. Most of the time this is the problem. In front of the tranny there is a rubber boot peel that boot back and put some High temp grease on the rod. This should get rid of the noise.
If not then it's something else bigger.
If not then it's something else bigger.
#10
#11
Well I went to the Machanic to install my new shocks, while I was there I asked him my clutch is making a squeeking noise. After he looked around he knew exactly where to go, it turns out that the FORK in the Slave Cylinder is vibrating due to the Clutch Cylinder. He bleeded my slave cylinder and the squeeking went away, but its back again today Should I try greasing it?
Thread
Thread Starter
Forum
Replies
Last Post
RAD69
Integra Technical Questions and Tips
5
08-23-2005 04:12 PM