boogie

I'm currently driving a 94 teg, and the previous owners put these shitty *** foglights in the bumper. Unfortunately instead of mounting them where the OEM fogs would normally be, they actually cut into the middle bar of the front grill to install them.

Personally, I think this looks like crap, so what I want to have done is to cut out that entire middle piece and actually have just like a black mesh grill installed. I've seen the DIY stuff over on TI, but really don't feel like doing any kinda body work to fill in the gaps that are left after you cut out the middle bar.

Can anyone recommend some place that can do this for me and not totally rape me on labour? I'm not even worried about the paint as I can get that done for cheap afterwards. I just need someone to cut out the bar, fill in the gaps, and maybe install a grill.

Thanks for any suggestions!

its me.. mario

why do you need to cut and fill if you're going to put a grill on anyways?

boogie

It just looks really ugly b/c they cut out two pieces of the middle bar already to install those foglights.

boogie

I forgot to mention, that my car and hence the middle bar is white. So even if I was to put a grill up, you would totally see the bar underneath it still.

Logik

Go see Jimmy at Autotrin. 777 Warden Ave. Unit #16B (at Eglinton Across from the Wal-mart) Very reasonable and wokrs on Tegs and custom front ends all the time.


Tell em I sent you, he'll hook you up.

boogie

Cool thanks man...I'll check 'em out

JEFFOS69

Why dont you just remove the grill and leave it open?

boogie

I could do that too, but it leaves those little notches in the bumper where the middle piece was cutout. I want to try and keep my car looking C-L-E-A-N...LOL

It's pretty much stock right now, so just cutting that piece out will make it look G-H-E-T-T-O...

JEFFOS69

Dont look really ghetto to me - just make your car faster and dont worry about the small notches no one notices lol. Whatever you do dont get one of the grillcraft grills theyre terrible.

FuzzyLS BRO

i cut out the middle bar and shaved the holes myself. it looks nicer IMO

boogie

Did you fill in the wedges left behind from the bar? I can't tell from that pic.

FuzzyLS BRO

^yes i did.

boogie

What did you use to fill the body in with?

dc24me

with 94-94 used bumpers going for so cheap nowadays used, it might be cheaper for you to pick one up for $50.00 instead of paying someone epoxy that piece back in.

boogie

hmmm...anyone know where I can pick up a 94-97 bumper for cheap? LOL

I'll probably repost this in the WTB section...

JEFFOS69

The centre bar is ugly though - go with the bar removal and fill idea

boogie

I do like the look of that better...but then I'm gonna want to put a lip on it as well...LOL

boogie

What's wrong with the Grillcraft grilles? I was thinkin' about getting one of those and just installing it myself..

WildoutWhiteGSR

they look like poo on the 94-97 front end

boogie

I don't think they look that bad...I figure this would be a lot cheaper than getting it done at a shop...

boogie

er...wait...I was talking about the Grille-tech grills...Are those any different from the Grille Craft grills???

FuzzyLS BRO

i don't then they are any different. i just filled the holes with bondo! bondo fixes all!