cdev0519

ok so my b18 is out and ready to swap but the b20 wires on the motor i got from jdmengineland are all cut. is there some way to swap out the b18 wiring harness onto the b20 and how would i go about doing that?

D.T.P

iTrader: (3)

I believe the b18b and b20 have the same wiring harnesses. So everything should transfer over without any problems.

cdev0519

ok sounds good.thats what i thought. im going to give it a try today hopefully all goes well

rubby-d

people even use there b18a harness when they put the b20 in ther da's lol just gotta use b18 dizzy or something like that

D.T.P

iTrader: (3)

^^The only reason you would use your own dizzy is if OBD doesnt match. So lets say obd2 car and obd1 motor.

rubby-d

ye well thats what im saying when ppl put a b20 in a da or something ..

cdev0519

ok got it wired up just trying to figure out what to do with the ckf sensor? ive been reading about splicing it. does anyone know where to get the quick splice thing ive been reading about or another way to just do it?