95'Teg_4dr

Now before I get flamed for being a moron, I do realize 95 SHOULD have OBD1, but i have checked every single place under the passenger side dash for the connector you need to jump to make the cel flash. Now, I should also say that this Integra was imported from California, and they have on some cars implemented OBD2 before it was legally required and are ahead in regards to emissions. My question is has anyone else ever ran into this? This connector SHOULD be under the passenger side dash near the kick panel+ ECU, although I have also looked at every square under there too as well as near the radio etc. Anyone drive a 94 or 95 imported from california or the states that might have some insight? Thanks

jugtoor

hey the obd1 connector is in that area have u looked up at all...it should look as if its coming from underneather the heat vent...i dunno how to explain it past that...also if its obd check for the connecter its almost opposite where the obd1 is....just look along the inside of the passenger side center console a little bit past the stereo...if u get what i'm saying lol. secondly why don't you read the code on the computer and google it...that should tell you which type of computer it is...

95'Teg_4dr

Alright thanks! I'll have to look at it tomorrow if its not snowing all day.

95'Teg_4dr

My friend Dan, whos on here as Tegra2g I think, has a 92 Integra and from what Ive heard the connector "should" be in the same location but mine couldnt be found where his was located either... not sure.