Toronto Integras - Torontos Acura Integra Club

Toronto Integras - Torontos Acura Integra Club (https://www.torontointegras.ca/)
-   Integra Technical Questions and Tips (https://www.torontointegras.ca/integra-technical-questions-tips-35/)
-   -   93 gsr looses power (https://www.torontointegras.ca/integra-technical-questions-tips-35/93-gsr-looses-power-37449/)

BurninRT 03-30-2009 04:28 PM

93 gsr looses power
 
i have a b17 thats been driving me crazy. just wondering if anyone else had a similar problem.. after the car warms up i notice that when i accelerate above 3000 rpm it feels like it looses power till it hits vtec. sometimes when its lagging i let go of the gas and press it again and it will be fine. during the winter it never acted up. now that the temperature is getting warmer it does it more often... no engine lights come on. ive changed plugs, wires, fuel filter, air filter, changed the cat (thinking maybe it would be plugged...) this problem used to be alot worse last summer. i changed the distributor, but i got a used one. the problem got better but its still there. could it be i got another bad distributor?? any ideas? thanks.

Buff4Prez Yo 03-30-2009 05:55 PM

check the timing. is it throwing any CEL's?

BurninRT 03-30-2009 07:33 PM

no cel comes up... i thought maybe timing but it would do it all the time. mine only does it randomly.

99jdmintegra86 03-31-2009 11:46 AM

its garbage that why......LOL RT!!!!

3NE 2NR 03-31-2009 02:05 PM

it might be the dizzy it self !

freestyle 04-15-2009 08:51 PM

check all ur ground points, make sure they're not corroded

BurninRT 04-15-2009 09:50 PM

I didnt check that but i will for sure..

Lonely Racer 04-16-2009 10:46 AM

sounds like ur dizzy, wires or spark plugs

cre8tunes 06-17-2009 08:33 AM

check the cataletic it happened to my brother and another friend of mine. In vtec it felt like the car wasnt moving.

b17gsr 06-25-2009 06:02 PM

Could also be a MAP or TPS sensor problem. Any vacuum leaks?

nate 06-26-2009 01:38 PM

ive seen this a couple times, turned out to be distributor timing every time (maybe just luck?) when you replaced the dizzy did you use a timing gun? try advancing it just a tad and see if that helps as well.

untouchable94 06-28-2009 02:17 AM

My 94 did the samething once in a while.... right... cap and rotor use dialetric graese on the wire ends and make sure your coil wires are tight it worked for me


All times are GMT -5. The time now is 04:29 AM.


© 2024 MH Sub I, LLC dba Internet Brands