- ViS Carbon Fiber Hatch With FAL plexiglass installed- Weighs like 15 pounds compared to 60+ on stock hatch and glass
- Comes installed with trim on glass(not like Orthrows cheap install) and has factory fit
- Baller status hatch! One of a kind!
- Less than 10 Hours outside as car barely comes out!
- No scratches, Mint condition
- $1100 firm.


- Airwalker Front Bumper for JDM front integra- Authentic!
- ONLY ONE IN CANADA (RARE AS HELL)
- NOT BYS THIS IS ORIGINAL AIRWALKER.
- FOR ALL THE CLOWNS WHO DONT KNOW THE DIFFERENCE, AIRWALKER WAS THE ORIGINAL COMPANY FROM JAPAN THAT MADE ALL THESE BUMPERS, BYS(Back Yard Special) COPIES(licenced) THEM AND WRAPS THE BOTTOMS WITH KEVLAR. Will be sold primer and ready for paint!
- $500 Obo

Link to walker japan (air walker) - http://www.walker-j.co.jp/index2-e.html

-Skunk2 Pro3 Cams
- Brand new
- 600 FIRM

info can be found here - http://www.skunk2.com/engine-2.php?code=CSPB



AVID B SERIES RACE SHAFTS! These shafts can handle well up to 500 whp. 10x beefier than oem shafts! - $300 FIRM



JDM FRONT SEIBON CARBON FIBRE HOOD with red sparco hood pins - $500


CUSCO 5 POINT HALF CAGE (blk w padding) - $500Nexx Race Seats with side mount brackets and low rails (seats weigh under 10 lbs) - $500



GSR intake manifold - 50 obo
-p75 obd2a ls/rs/gs computer - 50



98 sohc d16y7 motor and tranny(has rod knock) , clutch is good and tranny shifts fine- Will take any offer



p72 type r/gsr ac torque bracket - Best offer


OEM B series wires (good shape) - 20 bucks each (2sets)
Type R scatter sheild tranny brace - 50 obo


B-series IACV in good condition (2wire) - 30 bucks
B-series intermediate shaft, bearing is in good shape - 50 obo
Clutch fork rubber cover - 20 bucks
Kensai twin loop muffler (very quite) - 50 bucks


EK stock mounts - 50 firm


B-Series Fuel Rails - 10 bucks each (3sets)



DC EG B-SERIES SWAP T Bracket and driver post mount(2) - 40 each or 80 for all


B-series Oem clutches (good shape, 1 small spline, 1 big spline) - 40 each


OEM ACURA 1997-1999 CL heated passenger seat in mint shape - 80 bucks


mazda mx6 front lower ball joints - 20 for both sides BNIB - 20 obo

Location:
- West end

Contact:
- jborreta@hotmail.com

 

will the cl seat fit an 2k integra? will all 4 bolts fit?

 

I havent tried but your more than welcome to try to fit it if you want.

 

Can you deliver the carbon fiber hood??

 

i will deliver to oshawa for 40bucks

 

bump ek mounts sold

 

bump skunk2 pro3 sold

 

hey is that the best you could do for the hatch.