Gord Bush built B20 VTEC motor
#1
Gord Bush built B20 VTEC motor
Please email me with any questions. DO NOT PM me.
kurtgunnis@hotmail.com
This motor was built by Gord Bush for a friend of mine. The motor was installed in a car I purchased recently. I would love to hold on to this motor but money just doesnt allow it.
This motor recieved tuning since the first time it started up. The motor was only every street tuned. I do not know how much power it makes. The engine revs up so effortlessly. I can only compare it to a bike engine.
I really want to sell the motor as a whole unless the right offers comes along. I might be willing sell just the head or block with different combinations of parts.
$4500
Bolt on's
new MDT TRI Y header, Hytech knock off
Skunk 2 68mm Throttle body
JG Edlebrock Victor X intake manifold
AEM fuel pressure regulator
RC 440 injectors
Mugen oil cap
B20 VTEC oil pressure line, AN fittings with stainless steel hose
ACT street disk with OEM TYPE R pressure plate
Fidanza 8lb flywheel
New timming belt and water pump
TYPE R oil pan and oil pick up
Unorthidox light weight crank pulley
Type R head
Port and polish
ARP head studs
New TYPE R lost motion assembly
Crower titainum retainers
Crower dual vave springs
Ferrea valves
Web camshafts
B20B4 Block
Golden eagle pistons
Golden eagle Rods
Golden eagle rod bolts
Knife edged & balanced crank
New Honda bearings
Z10 Crank girdle
kurtgunnis@hotmail.com
kurtgunnis@hotmail.com
This motor was built by Gord Bush for a friend of mine. The motor was installed in a car I purchased recently. I would love to hold on to this motor but money just doesnt allow it.
This motor recieved tuning since the first time it started up. The motor was only every street tuned. I do not know how much power it makes. The engine revs up so effortlessly. I can only compare it to a bike engine.
I really want to sell the motor as a whole unless the right offers comes along. I might be willing sell just the head or block with different combinations of parts.
$4500
Bolt on's
new MDT TRI Y header, Hytech knock off
Skunk 2 68mm Throttle body
JG Edlebrock Victor X intake manifold
AEM fuel pressure regulator
RC 440 injectors
Mugen oil cap
B20 VTEC oil pressure line, AN fittings with stainless steel hose
ACT street disk with OEM TYPE R pressure plate
Fidanza 8lb flywheel
New timming belt and water pump
TYPE R oil pan and oil pick up
Unorthidox light weight crank pulley
Type R head
Port and polish
ARP head studs
New TYPE R lost motion assembly
Crower titainum retainers
Crower dual vave springs
Ferrea valves
Web camshafts
B20B4 Block
Golden eagle pistons
Golden eagle Rods
Golden eagle rod bolts
Knife edged & balanced crank
New Honda bearings
Z10 Crank girdle
kurtgunnis@hotmail.com
Last edited by Gunns; 07-24-2008 at 12:28 AM.
#3
#5
#6
#8
#9
#10
#11
Something like that should make 225WHP minimum, wish i had a civic shell lying around to throw that in!
Thread
Thread Starter
Forum
Replies
Last Post
nuvolari
Integra Parts For Sale
1
12-27-2009 02:57 PM
8500 RPM
Integra Parts For Sale
0
06-24-2009 08:29 PM