1990 acura integra ls
#1
1990 acura integra ls
Hey guys most of you seen my integra and know what its about so here it is.
Okay down to the point
-b16a motor with ls tranny
-Tune up just done ngk wires and plugs
-New rad, new battery
-One piece headlights
-93 front bumper
-Greddy 2 1/2 exhaust
-Brakes are about 70% all around
-Tokico blue struts and chopped springs
-Compustar 2 way alarm
Other than that the car runs mint and pulls strong. It's black on black but the body needs some serious body work. Nothing thats to bad it needs a trunk lid, rear quarters and i guess a hood. It's a good diy for whoever.
Asking $1000 obo no part outs/open to trades. Located in toronto
Email - shaunleblanc_100@hotmail.com, or pm me on t.i
Okay down to the point
-b16a motor with ls tranny
-Tune up just done ngk wires and plugs
-New rad, new battery
-One piece headlights
-93 front bumper
-Greddy 2 1/2 exhaust
-Brakes are about 70% all around
-Tokico blue struts and chopped springs
-Compustar 2 way alarm
Other than that the car runs mint and pulls strong. It's black on black but the body needs some serious body work. Nothing thats to bad it needs a trunk lid, rear quarters and i guess a hood. It's a good diy for whoever.
Asking $1000 obo no part outs/open to trades. Located in toronto
Email - shaunleblanc_100@hotmail.com, or pm me on t.i
Last edited by ls/vtec; 08-15-2008 at 02:15 PM.
#4
hey, I got a few comments to make.. 1st off, I like your battery tie down lol. That looks like a 2nd gen b16 because of the valve cover but the intake manifold is definately not a b16a2.. Also your AC has been removed which is a good thing in this case.. Who did the swap ??
#6
hey, I got a few comments to make.. 1st off, I like your battery tie down lol. That looks like a 2nd gen b16 because of the valve cover but the intake manifold is definately not a b16a2.. Also your AC has been removed which is a good thing in this case.. Who did the swap ??
#11
#13
#14
#16
Thread
Thread Starter
Forum
Replies
Last Post