Break lights and blinkers stay on
#1
Break lights and blinkers stay on
So the title tells it how it is..My break lights and blinkers stay on, i tried to take out the fuses. didnt fix the problem. the only way they go off if i disconnect the battery, anyone ever had a similar problem?
#2
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Join Date: Apr 2009
Location: Burlington
Posts: 5,142
Re: Break lights and blinkers stay on
check the wiring at the tail light for corrosion at the sockets and at the connections. Because seem like it's back feeding it's power from the parking lights system.
#4
There's plenty to do outside my room but I choose not to!
iTrader: (5)
Join Date: Apr 2009
Location: Burlington
Posts: 5,142
Re: Break lights and blinkers stay on
Break switch behind brake pad? But no I would not say it's the brake switch that's on the brake pedal. Plus there is no sensors on the brake pads.
It's most likely a electrical problem.
It's most likely a electrical problem.
#5
Re: Break lights and blinkers stay on
That problem will happen if the ground on the tail light harness is not connected on the bolt that holds the actual light in. It's a little plastic clip that goes over the bolt lol i don't know how to describe it any simpler Good luck
Thread
Thread Starter
Forum
Replies
Last Post
danny.t
Integra Technical Questions and Tips
10
09-08-2009 09:39 PM