WTT: Yonaka Racing Seats FS:Sk2 Shift Knob, Mugen Replica Lip, HighFlow Cat, Tie Bar
what up!
i'm interested in the mugen lip and the rear lower tie bar ( fits 1996 integra ls?) i'm willing to offer $60 for both.
email me at louist29@hotmail.com
or give me a ring at 647-200-6446
Thanks
i'm interested in the mugen lip and the rear lower tie bar ( fits 1996 integra ls?) i'm willing to offer $60 for both.
email me at louist29@hotmail.com
or give me a ring at 647-200-6446
Thanks
How to put the ABS lip on:
tape the lip onto the bumper with masking tape to hold the lip in place, then you heat up the lip's edges with a heat gun (or blowdryer but takes longer). then use a piece of pipe/wood press that soggy plastic edge into shape of your bumper, wait 5 mins for the plastic to dry, and do other side. then just drill mounting holes, and install with some stainless steel (to avoid rust)tap screws!
Hope this helps.
tape the lip onto the bumper with masking tape to hold the lip in place, then you heat up the lip's edges with a heat gun (or blowdryer but takes longer). then use a piece of pipe/wood press that soggy plastic edge into shape of your bumper, wait 5 mins for the plastic to dry, and do other side. then just drill mounting holes, and install with some stainless steel (to avoid rust)tap screws!
Hope this helps.
How to put the ABS lip on:
tape the lip onto the bumper with masking tape to hold the lip in place, then you heat up the lip's edges with a heat gun (or blowdryer but takes longer). then use a piece of pipe/wood press that soggy plastic edge into shape of your bumper, wait 5 mins for the plastic to dry, and do other side. then just drill mounting holes, and install with some stainless steel (to avoid rust)tap screws!
Hope this helps.
tape the lip onto the bumper with masking tape to hold the lip in place, then you heat up the lip's edges with a heat gun (or blowdryer but takes longer). then use a piece of pipe/wood press that soggy plastic edge into shape of your bumper, wait 5 mins for the plastic to dry, and do other side. then just drill mounting holes, and install with some stainless steel (to avoid rust)tap screws!
Hope this helps.
i'll pass this information to who buys the lip
or if i decide to keep it


