picked up my forged CP pistons 9:1 compression the other day (thanks again corey!) and i'm dropping the block and pistons off to the machine shop tomorow to get it bored and honed. this turbo build is finally coming along

 

sweet!

you sure those are 9:1 and not 9.7:1+? the dome looks to flat to be 9:1....

either way they will work great.

 

Very nice!!

So when's the deadline for this motor build?? :GrinDev:

 

If you dont mind me asking.... what is you totatl budget for this build... just wondering what the cost is of turbo'ing a Integra. Doing the job correct, by this I mean building a car that will always start and run fine and not worrying about making the most powa.

 

lol nice fuzzy.
i think you can make any car that is turbo reliable so long as you get a very good tune.

 

Those will look awesome parked at Wal-Mart!

 

^haha..yes..yes they will!

budget kinda went out the window since this started out as a simple NA build. i decided to go all out because this is the last thing i have to do to the car. i'm building the motor properley, with components for boost, and when it comes to turbo parts, i'm not cheaping out. i know i can make alot more power but i'm just aiming for 300whp give or take.

 

Good luck! Save some money for tuning

Can't wait to see pics of the finished project

DAN

 

^thanks man, the motor will only be started to check for leaks (and to make sure the thing runs :P) and then it will be towed to the dyno.

 

lol it always helps when the car will start

 

awesome. good luck with the build j. what kinda engine management were you planning on going with?

 

^thanks mang, but i don't have volks but it'll be tuned with chrome pro

 

chrome? is that like vtech?

 

some nice pistons to go with the mani.

good luck with the build man

 

holy crap, look at that camera quality....damn b....lol

bling bling on the pistons

 

Looks like we might have a Boost vs. NA show down next spring... :P