Would 98+ foglights fit a 94-97 bumper?
 

94 Jdm Oem Foglights Installed

you mean turn signals? No.

no
 

this question has been asked before. no they will not fit a 94-97 bumper. unless you do some HEAVY cutting. Just get the small yellow OEMs that go in the corners.

rotfl. how do you get turn signals from fog lights lol

he clearly stated what he wanted to know..



but as for the OP 98+ fog lights can be fitted as mentioned above, but you'll have to do alot of hacking. get the si-g ones.

well I currently have 94 USD OEM ones but one side is damaged and was thinking of getting JDM 94 yellow foglights... but I kinda like the 98 bumper where its all emtpy without any brackets... so therefore maybe I can cut away all the plastic and make it look like a 998 bumper :D

you know how the saying goes... " if it doesnt fit.... MAKE IT FIT!" :D

NO they won't fit, but if they are OEM, I will buy them off you. ;)

Well I purchased a set of JDM yellow FOglights and tried to install them.. but guess what! the old sets were STUCK.. the screws were all rusted and now strip! any ideas how i can get them out?

right
 

jdmcb7 is right i was advise that accord mounting brackets wouldnt fit into a integra but hey guess what. my 98+ fogs fit my 98 bumper and theyre mounted on accord mounting brackets. doesnt looks any different, cant tell the difference. so ure right if it doesnt fit make it fit. in this case its a little overboard.

Well it turns out that one of the foglights that I bought off a member on this site doesnt work.. how nice !!

have you tried changing the bulb?

no not yet, I am still have trouble trying to get the old fog lights off, the screws are rusted and stripped.. I went to CND tire and bought some stripped screw removal bits..

I had that problem years ago when I was parting out a 97 front-end. I tried using those removal bits and that didn't do anything. I was basically forced to rip out the fogs from the bumper. Of course I made sure to cause as little damage as possible in the process.

hopefully it wont come to that, I want to use the current harness and just replace the lights, the harness the guy gave me is in bad shape.

After many hours of swearing, thinking and with some help of many tools I was able to move the USD OEM foglights and install JDM OEM foglights. I'll take some pics next time, but I have a problem, once the covers go on, the light itself isnt centered to the plastic cover.. also one side is about 1-1 1/2 pointing higher than the other, is there a way to adjust vertically?