will it be as quiet as stock if..
i cut the rear of bc2
and weld on a piece to install stock mufller? or will it be stilll loud? |
why not just reinstall your stock muffler instead of hacking up your bc2? :confused:
|
because i have jdm length header. and to put the stock midpipe back
its a lot more hassel and maybe later on i can put some other aftermarket axleback with bc2 pipe if i want to. so will it be almost near stock if i do that?? |
the only exhaust that sounds near stock is mugen, smsp, hytech, apexi ws and rsr ex-mag.
No it won't solve your problem, just sell your exhaust and buy a quieter one or put the stock one back on. Your not the only one with a jdm length header... |
^ are you saying it will be still very very loud?
or will it still make noise but quiet enough for daily? and what do i need in order to put my stock cat+back on a JDM length header? |
custom length cat or cut and extend your midpipe.
|
alex have u found out the measurement yet? :P
zoro was closed. =( |
Jdm Header to USDM B-pipe : 16.5"
Jdm Header to JDM B-pipe : 12" USDM header to USDM B-pipe : 17.5" http://www.honda-tech.com/zerothread?id=609535 if you use the bc midpipe it will be louder than stock, due to the smaller resonator. |
^thanks alex~
yeah i think cutting bc2 is a bad idea lol ..... |
I hav a JDM 4-1 on my ITR, and a stock exhaust. I went to zorro, and they tailored a custom high flow cat for $265.00, works great.
Don't waste a perfectly good BC2 exhaust. You should be able to sell it without any problems. |
^ lol thats expensive.
|
Originally Posted by canttx
(Post 162790)
Jdm Header to USDM B-pipe : 16.5"
Jdm Header to JDM B-pipe : 12" USDM header to USDM B-pipe : 17.5" http://www.honda-tech.com/zerothread?id=609535 if you use the bc midpipe it will be louder than stock, due to the smaller resonator. so to clarify 16.5" - USDM CAT Length = the length of the 2.5"->2.25" flange i have to get?? |
if you want to get a universal high flow cat then bring it to a muffler shop and have them measure the distance between your jdm header and your usdm midpipe. either way just go to a muffler shop and decide what you want to do...they can fab up an adapter or make you a custom sized cat. I brought my own highflow cat and they charged me like $30-$60 to extend it and flange it.
|
All times are GMT -5. The time now is 09:45 PM. |
© 2024 MH Sub I, LLC dba Internet Brands