shaving side panels
 

How does everyone go about shaving down their side panels?

Did you do it yourself? If so, how?

or did you get it done at a body shop?

you mean side moldings??

I used a Schick Quattro Titanium for shaving:

http://www.schickquattro.ca/

side mouldings
 

yes, the side mouldings

i had them taken off, then the holes welded up, then smothed over. they came out decent; a little wavy tho.

don't shave it unless u get it done professionally cause thast where prime spots rust after

type r doors and then shave the quarter panels
very easy