sedan rear bumper install
 

I have installed a 2 door gen3 rear bumper before, but was wondering if there is anything different about installing a sedan gen3 rear bumper?

Thanks

Yeah, you have to watch out for the 2 extra doors.

And the bumper fluid resevoir is in a different location.

The bolts holding the re-bar bearings are a different size (I think 14mm)

Good luck!

Don't forget, you also require new master clip knock-washers when installing a new bumper on a sedan. This is to hold the bumper fluid resevoir in it's place.

Assholes! :p :loco:

This bumper fluid resevoir, is for a sedan right?

So would this install be difficult compared to a 2door rear bumper?

Yes, the resevoir is only on the sedan models. I beleive they had different locations and sizes for different trim levels.

I was wrong....the bolts are 18mm!

Make sure you drain the fluid first, or you'll have a huge mess on your hands....