hey guys the dc seems to be puking oil and i took a look underneath its dripping from what seems to be the gasket for the oil pan any thoughts on how much it would cost to fix and i'm assuming this would be done with an oil change anything else i should do

 

its an easy fix... just drain the oil first, then remove the oil pan.. clean out the oil pan... lay down the gasket... bolt it back up... change the filter, add oil.. drive your hear out.

 

what do the gaskets run at honda

 

i dont think you need to go to honda for one. and it cant be more then 30-40$ i'ts just a piece of rubber. Just zip all the 10mm i belive it is bolts off and clean up the surface of the block and install the new gasket and torque the bolts to spec so it dosn't leak again and you don't break them by over tightening.

 

Hey everyone jus looking for input for a exhaust system im looking for some power increase but really what im after is keeping it quiet i wouldnt mind a nice low tone but im really sick of getting boned with uneccesary noise tickets and lastely can anyone point me in the direction of a good exhaust place

 

just buy a world sport 2 exhaust. very quiet


you can do the oil pan yourself.. undo the header, remove the inspection plate bolts, and take teh 10 mms of the pan. put new gasket on and put thermal silicone around the corners. then re-install in tighten the bolts to hand tight. dont break em.

 

sikktegra good call with the ws2 exhaust but is there a way to get it maybe slightly quieter and who in toronto would sell this exhaust

 

ws2 is about as quiet as they get without going stock.

 

QFT... and it looks nice too... doesnt look like a huge fart can.