JDM steering wheel (horn) install on USDM Teg
Ok so I removed the old wheel and SRS unit with harness thing.
but now I have no clue how to hook up the horn. The horn button has two wires connected to steering wheel base. the base dosen't touch anything due to the gap where the srs unit used to be. Anyone done this before?? please help. The steering wheel fits it is the Horn that is the problem |
You have to tap into the horn wire located above the fuse box. Then, run the new lead up the steering column with a ring terminal at the end. Secure the ring terminal with a screw from the original ABS module in one of the 3 holes for the module... take some plumbers coil or even a paper clip and bend it so that it touches the base of the steering wheel hub.
Kind of hard to explain... I could help you do it after i'm done exams next week. Try searching the net too.. u might find some detailed instructions. |
I think I get it...I basically needed to know if you had to buy a new piece or if you could tap the wire. I'll give it a shot. Thanks Man and good luck with your exams!
|
I got it! thanks Vince, I might need another lip. I'll let u know.
|
Originally Posted by Phil
I got it! thanks Vince, I might need another lip. I'll let u know.
|
|
no car pics? i always wanted to see a pic of your car.. sounds nice :o
|
Sure Phil... just let me know, i'm placing an order for lips in the next week or so.
|
Phil's car is "top secret"
|
All times are GMT -5. The time now is 06:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands