exhaust question
 

i have 2000 SE integra with the stock motor

i'm planning to have the ITR header which is 2.5" outlet

and trying to order an aftermarket exhaust

what should i order in order to directly bolt on ???

what's the difference between 96-01 LS ,GS model and 99-01 GSR
00-01 TYPE R

lilttle bit confused..

is that a length wise ? or between the rear lower control arm ??

planning to swap the 5lug conversion as well.

should i order the exhaust for the 00-01 type R for the future ?

need help ! thx

Only The JDM Header has a 2.5" collector; USDM collectors are 2"

http://www.team-integra.net/sections...?ArticleID=554

Read through the above article; If you have anymore questions, post them here.

I have the JDM ITR header and my question is what to fit for the after market b-pipe

You need to be a little more clear... are you looking for a cat-back exhaust?

yes Iam looking for a Cat - back exhaust

specifically clearly i'm looking for HKS hi-power Cat back system

i have the JDM ITR header which is the 2.5" and looks like there' arent' too much of 2.5" HKS hi pwer exhaust system for the 2000 SE

need help anyone ?? ?

iv got a 4-1 with 2.5 collector into magnaflow cat an hks hi power catback on my Da

!!! is there an 2.5 inch inlet for the HKS hi power ???

Or do u have to use the reducer 2.5 to 2.25

my header came with a flexpipe and adaptor for 2.5into 2.25 (xs engineering).

any pipe bending shop will be able to make you 1

ya.. i can use reducer or flex pipe goes 2.5' to 2.25 but i would like to keep the 2.5 " all the way so

is there any????

Plenty of other manufacturers... Do some searching

Try GReddy, Skunk2, Thermal R&D, etc etc.