Defrost light is out.
Yup.
After you remove the defroster mechanism, there's a twist release underneath.
It's a rubber sheath and bulb holder.
You'll need to replace it with either a Nexxtech micro lamp (#2721092) from The Source, or something I picked up at Active Electronics called a T-1 Bi-Pin lamp. The T-1 is shorter, and you'll need to do a tiny spot solder. Otherwise I'd recommend the Nexxtech one b/c it has longer lead wires.
The lamp is a 12.0 V 0.06 Amp or 60 mA bulb.
After you remove the defroster mechanism, there's a twist release underneath.
It's a rubber sheath and bulb holder.
You'll need to replace it with either a Nexxtech micro lamp (#2721092) from The Source, or something I picked up at Active Electronics called a T-1 Bi-Pin lamp. The T-1 is shorter, and you'll need to do a tiny spot solder. Otherwise I'd recommend the Nexxtech one b/c it has longer lead wires.
The lamp is a 12.0 V 0.06 Amp or 60 mA bulb.
you can get the replacement bulb from the dealer at 6 bucks, just pop out the fog switch with a flat screw driver and you can pull the cartiage out by loosen the clip on the side and it's the brown bulb to be replaced
good someone posted this mine is burnt out too. Overdose what does it matter if it was on or off once you put it in wont you know if it turns on its on and if its off it wont light up? Correct me if im wrong.
Thread
Thread Starter
Forum
Replies
Last Post
Cheetah
Integra Technical Questions and Tips
1
Jan 21, 2009 12:11 PM
-=GMAN=-
Integra Technical Questions and Tips
6
Aug 29, 2005 06:25 PM





