D.T.P |
01-29-2011 02:44 AM |
Cel is supposed to go on solid when key is in on position but engine is off, then disappear. If light flashes when car is running, that means a misfire. Though it should store a code and leave cel light on.
What you should do is check if any codes are stored. Now for life of me I cannot remember whether the service plug is on driver side or passenger, so somebody please contribute. (Pretty sure its under the glove box right in the corner). Either way, once you find it, (most likely in a green rubber boot if not removed), get a paper clip or piece of thin wire and just short it out. Once that's done, turn ignition on but do NOT start the car. Watch the cel light for blinks. Short blinks are 1s and long blinks are 10s. If anything shows up, report back. Otherwise ignore it.
|