Fieldzy09 |
10-07-2008 02:56 PM |
Check Engine light..
So i was drving home today from Acura on Main in Hamilton..there was a little piece of wood sitting on the road that i missed with my eyes and ended up hittin it with my left side tire. I thought just incase something might be wrong ill dbl check, so i pulled over into some car cleaning deal (just happend to be the next avalable to pull over into) and checked the tires and everything was good..so i thought well maybe it wasnt as bad.. so i then got into my car (which i left running) and it was running rough, shaking more so than usual, I then see the ugly yellow light screaming on my dash, so i popped the hood to see if anything had come unplugged, detached, etc. so i continued driving home because my code reader was at home so i went straight there..got home plugged the reader in and came out with PO304 Misfire Cylinder 4. So i called up -----------, and he suggested remvoing the dizzy cap and running some sand paper to the contacts. So i pulled the dizzy cap off and cleaned the contacts and the contact on the rotor. Put it all back together, cleared the code. and started it up. This time it ran better but still not A1.
As far as i know now the CEL is off but i only had it running for about a minute and a half since it was cleared.. since it still runs a little rough (shaking and put put put sound out the pipe) what else do you think should be checked? Did i not clean the contacts good enough? Do i need some wires? Or something with the dizzy?
All help is appreciated..
|