ok, new here so HELLO ALL, anyways, new to the Integra and my question is this, I know how to check the CEL codes but! in my car there is no "Dummy harness" there are however to plugs that go nowhere, 1 2prong and 1 3 prong, now I know that I jump the 2 prong to get the codes to flash, question is wire colors?? mine are Green and Brown, when I jump I get one long and that's it, please help me, been fighting with this all day, thanks again.

 

BTW, my Teggy is a 93 GSR with a B20B

 

Gen2 (90-91) Pulling ECU/CEL Codes & Code List - Team Integra

Could this be your answer? I know it's for 90-91 but I don't think there is a difference.

 

You Sir...are a god!! thank you so much!! I assume key in and on right??

 

OK, tried the ECU light method and no blinks, assuming this is good, just change the plugs?

 

Are you getting a CEL code? Are you having a problem with your car?

 

the check engine light is on but no CEL codes thrown....?

 

Hmmm...and you are sure it's not the Maintenance light? the CEL and Maintenance light are two different things.

 

well that's what I'm wondering, I just got the car a know no history on it at all, I', gonna try changing the plugs and oil and keep my fingers crossed.

 

Which light is it?



OR

 

the bottom one

 

I went through this process.... http://www.team-integra.net/sections...?ArticleID=982 and didn't get any codes from it, so I'm assuming everything that way is fine, I've even tried the jumper test too and nothing, the only other thing I can think of is changing the plugs, wires and the oil, worked in my Civic

 

I find it weird that it's showing the light, but not pulling a code. If you can get your hands on an OBD1 reader, i'd recommend using that.

 

worst case,. I take it into Honda and get them to run it for me

 

Correction, there is no window on my ECU, therefor no code to see, damn it, I'm right back where I started