plzz help Vtec isnt workin after trany swap
#1
plzz help Vtec isnt workin after trany swap
can some 1 plz help me out i got a 88 cx with a jmd B18C i just did a tranny swap and ever since i have a engine light and cant even rev it out past 6k my vtec isnt workin iuno y , i check the solenoid its clickin , oil level is good , vss sensor is workin , tps sensor is good , all the grounds are good , wiring is good 2 , can some 1 plz help me out thnks alot
#3
yeh i got a CEL on but im not sure wha it could be , how do check it? do u kno where the jumper is on Ef9 civic?? id aprriciate it thnks
Last edited by b18cef9; 01-27-2008 at 09:41 AM.
#7
doesn't matter which OBD the engine is...only the ecu matters.
If its OBD0, then when the CEL is on there is a little light on the ECU itself that will flash (theres a hole in the ecu cover). Count the flashes.
If its OBD1 then you have to jump the service connector and count how many times the CEL flashes. The service connector on 88 CRXs are under the hood on the drivers side shock tower area, its a little 2 wire plug with nothing plugged into it.
If its OBD0, then when the CEL is on there is a little light on the ECU itself that will flash (theres a hole in the ecu cover). Count the flashes.
If its OBD1 then you have to jump the service connector and count how many times the CEL flashes. The service connector on 88 CRXs are under the hood on the drivers side shock tower area, its a little 2 wire plug with nothing plugged into it.
Thread
Thread Starter
Forum
Replies
Last Post