Break question
 

:wtf: OK i got a 1990 acura integra with abs, my car has a master cylider and a abs cylider. What my problem is the break seems to drop to the floor every once in a while, and also all the fluid from the master cylinder goes into a abs cylider over a period of a time. I was told to check for any leaks of break lines or anything like that and i did all the lines are mint and go inside the car so i didnt notice any leaks. Could it be the master cylinder? Any help would be great.. Thank you

i had same problem amir. Then it got to the point where my brake pedal was all way down to floor and brakes didnt work at all. Its Your master cylinder or your brake booster check for like corrosion, The reason why is once yur master cylinder goes or brake booster it leaks and you can tell rite away what the problem is. Or u could have water or air in your brake lines. That caused mine to go.

If your brake pedal goes to the floor when your rest your foot on it. Then bleed the brake lines first.

If it goes to the floor after bleeding it's your brake master cylinder.

How do you bleed the brakes?

Master cylider replaced problem solved ..


Get a person to pump the breaks from inside the car about 4 times and hold them down, while another person goes to the break caliper there should be a nipple turn the nipple untill fluid comes out. Close the fitting and tell your buddy to pump the breaks again 4 times and just keep repeting these steps to all 4 break calipers untill you find your breaks to be nice and hard ..