ABS PROBLEMS Help!!
Ok, to make a really long story short my ABS has not worked for the longest time A. becuase i took it to a shop my cousin said was good a few years ago to install springs and after i got the car back the light was on. To make the story short now I checked what code its throwing a week or so ago and it is the following
16 - RR Wheel Sensor (electrical noise/intermittent interruption) 17 - RL Wheel sensor (open/short to body ground/short to power 18 - RL Wheel Sensor (electrical noise/intermittent interruption) 81 - Central Processing Unit (CPU) Ok, so am i fcuked? any ideas of why the cpu would be not working? will this cost me ---- loads to get fixed? any help is appreciated Btw its a 2000 Gsr Thanks |
anyone? :confused:
|
check the ABS fuse first, if that's blown then it could be why the CPU isn't getting power causing the code.
|
Originally Posted by FuzzyLS BRO
check the ABS fuse first, if that's blown then it could be why the CPU isn't getting power causing the code.
|
make sure the abs sensors are all tight
|
16 - RR Wheel Sensor (electrical noise/intermittent interruption)
--> Remove the sensor and clean the tip. It's magnetic so it picks up junk. This code won't cause your ABS to stop working. 17 - RL Wheel sensor (open/short to body ground/short to power --> Check that the wire running over the control arm, probably damaged during the spring install. Repair the damaged wire or replace the sensor as a whole. This code will cause your ABS to stop working. 18 - RL Wheel Sensor (electrical noise/intermittent interruption) --> See above 81 - Central Processing Unit (CPU) --> Repair, replace the RL sensor and clear the codes and see if this comes up again. It shouldn't but if it does try swapping the ABS cumputer with a known good one. Good luck!! |
Originally Posted by stumpyf4
16 - RR Wheel Sensor (electrical noise/intermittent interruption)
--> Remove the sensor and clean the tip. It's magnetic so it picks up junk. This code won't cause your ABS to stop working. 17 - RL Wheel sensor (open/short to body ground/short to power --> Check that the wire running over the control arm, probably damaged during the spring install. Repair the damaged wire or replace the sensor as a whole. This code will cause your ABS to stop working. 18 - RL Wheel Sensor (electrical noise/intermittent interruption) --> See above 81 - Central Processing Unit (CPU) --> Repair, replace the RL sensor and clear the codes and see if this comes up again. It shouldn't but if it does try swapping the ABS cumputer with a known good one. Good luck!! |
i donno bout u guys but i prefer no abs...
|
All times are GMT -5. The time now is 07:16 AM. |
© 2024 MH Sub I, LLC dba Internet Brands