wtt obd2 to obd1 conversion harness for injectors
Junior Member
Joined: Jun 2009
Posts: 116
From: Burlington
If I read this correct you have an OBD2 car with OBD1 motor and you need your F.I. harness to connect.
Basically hunt down 4 new or used OBD1 injector pigtails. Cut off the OBD2 ones and solder on the new ones (use heat shrink).
I have done this and it works perfectly.
Basically hunt down 4 new or used OBD1 injector pigtails. Cut off the OBD2 ones and solder on the new ones (use heat shrink).
I have done this and it works perfectly.
Thread
Thread Starter
Forum
Replies
Last Post